How to Extend Suspenders with Suspender Extensions

Quick answer

Attach a pair of Suspender Extensions to your 5009 or 5055 suspenders to add 12 inches of length, giving big and tall builders a comfortable fit without buying new suspenders.

How to Attach Suspender Extensions

1. Remove your existing suspenders: Unclip the front and back of your suspenders from your tool belt or pants. Lay them flat so you can see both shoulder straps clearly. Do this on a clean surface so you don't lose any hardware.
2. Choose which side to extend: Decide if you need more length on one or both sides. Most big and tall builders extend both sides equally for balanced support. Extending only one side can cause your tool belt to tilt.
3. Attach the extension to the suspender buckle: Take one Suspender Extension and loop its leather end through the metal buckle at the bottom of the suspender strap. Pull it back through to secure it, just like you would with a belt. Make sure the leather is fully seated in the buckle and not twisted.
4. Clip the extension to your belt or pants: Use the metal clip on the free end of the extension to attach it to your tool belt or pants. Repeat steps 3 and 4 for the other side. Double-check that both clips are facing the same direction for a clean look.
5. Adjust the length and test the fit: Put on your tool belt and suspenders. Adjust the front and back buckles to distribute the load evenly. The belt should sit at your natural waist without riding up. If the belt still rides up, you may need to loosen the shoulder straps further or add the extensions on both sides.

What You Need

• Suspender Extensions (Pair): For the extra big and tall builder, a pair of these straps provide an additional 12” to the length of your suspenders. For use on our 5009 and 5055 suspenders and suspension systems. Made in USA! A single pair adds enough length to accommodate most tall or large frames, and the USA-made leather matches the durability of your existing gear.