Green Building Fastener Bag: What Fits and How to Organize

Quick answer

The Green Building Fastener Bag is built to hold a day's worth of fasteners plus the tools you need to set them, and with a deliberate loading order you can keep everything accessible without digging.

How to organize your Green Building Fastener Bag

1. Start with the tape holster: Slide your 35-foot tape measure into the side-by-side holster. Keep the tape's belt clip facing out so you can grab it with one hand. Common mistake: forcing a wider tape into the holster can stretch the leather and reduce its grip. Checkpoint: the tape should sit snugly but not require force to remove.
2. Load the angle square holster: Place your speed square or angle square in its dedicated holster, with the lip facing up for a quick pull. Common mistake: leaving the square in a general pocket where it slides under other tools. Checkpoint: you should be able to draw the square without moving anything else.
3. Organize the drill bits: Put the most-used drill bits in the holsters on the upper bag, grouped by size or type. Common mistake: mixing screwdriver bits and drill bits in the same holster, which makes you fumble. Checkpoint: each holster holds one bit type, and the bits are oriented so you can read the size markings.
4. Use the external sleeve pockets for small tools: Reserve the external sleeve pockets for items you reach for often, like a pencil, chalk line, or utility knife. Common mistake: filling these pockets with fasteners, which makes them bulge and blocks access to the main bag. Checkpoint: the pockets should close or lie flat without straining.
5. Sort fasteners by type in the main bag: Use small containers or bags inside the main compartment to separate nails, screws, and other fasteners by type and size. Common mistake: dumping loose fasteners directly into the bag, which makes them settle to the bottom and mix. Checkpoint: you can see the top of each container and pull it out without digging. After a few days of use, adjust the container sizes based on which fasteners you use most so the heaviest ones sit closest to the center of the bag.
6. Protect sharp tools with the Oxy Tool Shield: Wrap sharp edges—like chisels or awls—with the included Oxy Tool Shield before placing them in the main bag. Common mistake: leaving sharp tools bare where they can cut through other items or dull against metal. Checkpoint: every sharp tool is covered, and the shield stays in place when the bag is moved.

Product facts

• Green Building Fastener Bag: The Green Building Fastener Bag offers a side-by-side 35-foot tape holster, an upper bag with external sleeve pockets, drill bit holsters, and an angle square holster. You can keep measuring, marking, and drilling tools right next to your fasteners, so you don't have to reach for a separate tool belt or pouch.